Product Description

Benevento sunroof wind deflector designed to fit over factory installed sunroofs using 410 stainless clips, stainless screws, and thumb nylon nuts. No drilling required.

Product Details

• Amazon Sales Rank: #96130 in Automotive
• Brand: Benevento
• Model: BV1465Juke

Features

• Clip-On Sunroof Wind Deflector - Made in USA!
• No drilling or tape required - Hardware included
• Online installation video link: http://youtu.be/AtIz_LyIrS8
• Only fits model with an OEM factory-installed sunroof
• Easy to Install - Wind Deflector Installation Instructions 1. Open the sunroof 2. Place sunroof wind deflector in front of opening with curved side facing back. 3. Center deflector (If you can't determine the center, place a small piece of masking tape along sunroof front opening just out of the way and measure for center and mark it with a pencil, and also find the center of the deflector using the same method this will allow you to align for proper alignment for installation.) 4. TEMPORARILY tape the clips to the sunroof flange (lip or trim ring that you will find in OEM factory-installed sunroofs). 5. Put one screw thru the hole in the deflector and on into the hole in the top of the clip. You will have to exert quite a bit of pressure on the deflector to get the screw to feed thru the hole this is entirely normal. 6. Screw thumbnut from below and slowly tighten, allowing the open end of clip to clamp on lower edge of sunroof opening. 7. Repeat steps on other side, but you should tighten each side just a little as you go and keep deflector centered

Customer Reviews

Most helpful customer reviews

1 of 1 people found the following review helpful.
top quality
By Lisa Fryar
Very nice and well packed, I love my new visor on my new Nissan Juke. Pro-trim made my purchase a wonderful and pleasant experience as well as a top notched visor...THANKS